Burn any PC Video Format into DVD for Free

How to Easily Burn Any PC Video File into DVD Within Minutes (15 Video Formats Supported)
(Easy to Follow Tutorial)

Would you like to burn your FLV, Real Video, WMV and other video files direct to DVD without having to convert them first and then bringing them to a disc-authoring program?

Try out the open source DVD Flick which supports a total of 15 PC video file formats. Check out this DVD Flick Tutorial.

DVD Flick does its job admirably well for an open source program. If you're serious about producing DVDs from PC Video files, then this is the program for you.

You don't have to click on new project to get started with DVD Flick. 

Let's start the tutorial  by adding your clips (Add Title)first to DVD Flick and choose Save Project. It's advisable you do this as soon as possible after loading your clips to avoid redoing the task in case your computer 


DVD Flick supports the formats below.

If you have a file whose format is unlisted, then you can try loading it under All files *.*. 

Edit File

After you have loaded the file you can choose the edit title mode where you can set chapters for your title and even tweak the output aspect ratio.

 

DVD Capacitor Indicator

On loading the files, DVD Flick will reveal info related to it. You should note the length of the clip to see it doesn't exceed the DVD capacity.

 
DVD Flick provides a vertical indicator bar to your left to see how much disk space will be taken up.


The yellow bar shows that you have sufficient space in your DVD to accommodate your chosen files. If the bar turns red, then you should remove some files to free some space.

Project Settings 

Before you start burning your DVD, you could tweak the project settings so that you could obtain the desired result.


General 

You can set the target size to DVD or DVD Dual Layer and DVD RAM among others. If you want a high quality output albeit longer rendering time, then you could choose High under Encoder priority.

Video Settings 

Target format could be chosen as PAL, NTSC or NTSC-film. Encoding could be Normal, Fast, Fastest or Best. Target bit rate should in most cases be left at Auto-fit. Let DVD Flick set the bitrate according to the size of your DVD disc.

Audio Settings 

You may want to up or lower the volume of the original or leave it as it is at 100%. If you have a home theater system then you could opt for 5.1 surround.

Playback Settings 

If you have many titles added, then you would want to choose play the next file. However, if you have only one title, you can chose the Play it again option or Stop playing.

You can also choose Loop to first title when the player has finished with the last title.

Burning Settings 

The settings are pretty straightforward. But you may want DVD Flick to back up your project to disc for future use , in which case you tick near the blue icon. Otherwise you leave the setting as it is.

When you're done with your settings, click Accept and you can even use the settings as default if you don't want to make any changes for your next DVD Flick project.

Create DVD 

You need to have enough space in your hard disk to store the encoded DVD file. Otherwise, you would have to remove some titles so that there would be enough space to proceed.

DVD Burned 

I tried a ten-minute 24 MB FLV file and it took 14 minutes to encode and burn it to DVD. The resultant file had a size of 621MB. The quality of the movie, taking into account being encoded  from the FLV format was to my satisfaction. Anyway, the quality of the output will depend on the quality of your source video.